Asus N100I-EM-A Users Manual English - Page 14
Chassis intrusion header 4-1 pin_CHASSIS, LVDS Panel VCC Power Selection jumper 6-pin VCC_PWR_SEL
View all Asus N100I-EM-A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
2. Chassis intrusion header (4-1 pin_CHASSIS) This header is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a low-level signal to this connector when a chassis component is installed. The signal is then generated as a chassis intrusion event. CHASSIS PIN 1 +5VSB_ATX O_CASEOPEN GND Connector type HEADER 4p, K2, 2.54mm pitch 3. LVDS Panel VCC Power Selection jumper (6-pin VCC_PWR_SEL) VCC_PWR_SEL 4 2 1 3V (Default) 6 5 3 5V 12V Setting 3V (Default) 5V 12V Connector type Pins 1-2 3-4 5-6 HEADER 2 x 3p, 2.54mm pitch, S/T Chapter 2: Motherboard information 2-7
2-7
Chapter 2: Motherboard information
2.
Chassis intrusion header (4-1 pin_CHASSIS)
This header is for a chassis-mounted intrusion detection sensor or switch. Connect
one end of the chassis intrusion sensor or switch cable to this connector. The
chassis intrusion sensor or switch sends a low-level signal to this connector
when a chassis component is installed. The signal is then generated as a chassis
intrusion event.
+5VSB_ATX
O_CASEOPEN
GND
CHASSIS
PIN 1
Connector type
HEADER 4p, K2,
2.54mm pitch
Setting
Pins
3V (Default)
1-2
5V
3-4
12V
5-6
3.
LVDS Panel VCC Power Selection jumper (6-pin VCC_PWR_SEL)
12V
5V
1
3V
(Default)
VCC_PWR_SEL
3
4
5
6
2
Connector type
HEADER 2 x 3p, 2.54mm pitch, S/T