Asus N100I-EM-A Users Manual English - Page 40

Configuration options: [1] [2] Flow Control Flow control can prevent data loss from buffer overflow. When sending data, if the receiving buffers are full, a "stop" signal can be sent to stop the data flow. Once the buffers are empty, a "start" signal can be sent to re-start the flow. Hardware flow control uses two wires to send start/stop signals. Configuration options: [None] [Hardware RTS/CTS] VT-UTF8 Combo Key Support Allows you to enable or disable VT-UTF8 Combination Key Support for ANSI/ VT100 terminals. Configuration options: [Disabled] [Enabled] Recorder Mode With this mode enabled only text will be sent. This is to capture Terminal data. Configuration options: [Disabled] [Enabled] Resolution 100x31 Allows you to enable or disable extended terminal resolution. Configuration options: [Disabled] [Enabled] Putty KeyPad Allows you to select FunctionKey and KeyPad on Putty. Configuration options: [VT100] [LINUX] [XTERMR6] [SCO] [ESCN] [VT400] COM6(Pci Bus0,Dev0,Func0) (Disabled) NOTE: The following items can be configured only when AMT is provisioned. Console Redirection Settings Redirection COM Port Allows you to select a COM port to display redirection of Legacy OS and Legacy OPROM Messages. Configuration options: [COM1] [COM2] [COM3] [COM4] [COM5] [COM6(Pci Bus0,Dev0,Func0) (Disabled)] Resolution This allows you to set the number of rows and columns supported on the Legacy OS. Configuration options: [80x24] [80x25] Redirect After POST Configuration options: [Always Enable] [BootLoader] [Always Enable] Legacy Console Redirection is enabled for Legacy OS. [BootLoader] Legacy Console Redirection is disabled before booting to Legacy OS. 3.3.9 SATA Configuration This item allows you to configure SATA device options settings. SATA Controller(s) Chapter 3: BIOS setup 3-9