Asus ROG Rampage VI Extreme Encore Users Manual English - Page 91
APM Configuration, 3.6.9 HDD/SSD SMART Information, 3.6.13 Network Stack Configuration
![]() |
View all Asus ROG Rampage VI Extreme Encore manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 91 highlights
3.6.8 APM Configuration The items in this menu allow you to set system wake and sleep settings. ErP Ready This item allows you to switch off some power at S4+S5 or S5 to get the system ready for ErP requirement. When set to [Enabled], all other PME options are switched off. Configuration options: [Disabled] [Enable(S4+S5)] [Enable(S5)] 3.6.9 HDD/SSD SMART Information This menu displays the SMART information of the connected devices. NVM Express devices do not support SMART information. 3.6.10 NVMe Configuration This menu displays the NVMe controller and Drive information of the connected devices. 3.6.11 USB Configuration The items in this menu allow you to change the USB-related features. The Mass Storage Devices item shows the auto-detected values. If no USB device is detected, the item shows None. USB Single Port Control This item allows you to enable or disable the individual USB ports. Refer to section Motherboard layout for the location of the USB ports. 3.6.12 PCH-FW Configuration This item allows you to configure the firmware TPM. 3.6.13 Network Stack Configuration The items in this menu allow you to configure Ipv4 / Ipv6 PXE support. Chapter 3 ROG RAMPAGE VI EXTREME ENCORE 3-21
![](/manual_guide/products/asus-rog-rampage-vi-extreme-encore-users-manual-english-ee77c87/91.png)