Behringer MON800 Manual - Page 10
Audio Connections
View all Behringer MON800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
10 MINIMON MON800 User Manual 5. Audio Connections There are various ways to integrate the MON800 into your set-up. Depending on the application in question, you will need different sets of connecting cables. The cables to use are described below. 5.1 Connection with 1/4" or cinch cables Please use standard 1/4" or cinch cables to connect the MINIMON to other equipment. These cables have a 1/4" or cinch connector at each end. Connect the inputs and outputs of the MON800 to the respective connectors of the other devices. 5.2 Footswitch connection The MINIMON features a jack for the connection of a footswitch. Here, you can connect any commercially available footswitch with a 1/4" TS connector. As some footswitch models on the market have a different polarity, please be sure to use one that is appropriately wired. The correct wiring is shown in the illustration below. ¼" TS footswitch connector strain relief clamp sleeve tip tip tip sleeve shield sleeve Fig. 5.1: Wiring diagram of a hi-fi cinch cable sleeve pole 1/ground tip signal sleeve ground/shield tip sleeve strain relief clamp strain relief clamp sleeve tip sleeve ground/shield tip signal Fig. 5.2: Unbalanced cable with 1/4" TS connectors tip pole 2 The footswitch connects both poles momentarily Fig. 5.3: Wiring of a 1/4" TS connector for footswitch connection 5.3 Headphones connection The MINIMON has two jacks for headphones. Here, you can connect any standard pair of stereo headphones with a 1/4" TRS connector. For 3.5-mm plugs you need an appropriate adaptor. The correct wiring diagram is shown in the illustration below. ¼" TRS headphones connector strain relief clamp sleeve ring tip sleeve ground/shield ring right signal tip left signal Fig. 5.4: Wiring of a 1/4" TRS headphones connector