Beko BDG581 User Manual - Page 11

M Installation Product must be installed by a qualified person in accordance with the regulations in force. The manufacturer shall not be held responsible for damages arising from procedures carried out by unauthorized persons which may also void the warranty. Preparation of location and electrical and gas installation for the product is under customer's responsibility. A• DANGER The product must be installed in accordance with all local gas and/or electrical regulations. ^DANGER • Prior to installation, visually check if the product has any defects on it. If so, do not have it installed. Damaged products cause risks for your safety. Before installation To ensure that critical air gaps are maintained under the appliance, we recommend that this appliance is mounted on a solid base and that the feet do not sink into any carpet or soft flooring. The kitchen floor must be able to carry the weight of the appliance plus the additional weight of cookware and bakeware and food. above hotplate level allow a side clearance of 65mm between the appliance and any wall, partition or tall cupboard. • It can also be used in a free standing position. Allow a minimum distance of 750 mm above the hob surface. • (*) If a cooker hood is to be installed above the cooker, refer to cooker hood manufacturer' instructions regarding installation height (min 650 mm). • Movement of your appliance is most easily achieved by lifting the front as follows and pulling towards. Open the top oven door and the bottom oven door sufficiently to allow a comfortable grip on the underside front edge of the oven roofs. While gripping, it should be avoided to damage any grill elements or oven interior furniture. • The appliance corresponds to device class 1, i.e. it may be placed with the rear and one side to kitchen walls, kitchen furniture or equipment of any size. The kitchen furniture or equipment on the other side may only be of the same size or smaller. • Any kitchen furniture next to the appliance must be heat-resistant (100 °C min.). he appliance must be secured against overbalancing by using the supplied two safety chain on your oven. Fasten hook (1) to the kitchen wall (5) and connect safety chain (2) to the hook. 4 1=1 E 65 mm min II 65mm min tm It can be used with cabinets on ei her side but in order to have a minimum distance of 400mm 2 3 5 1 Hook (is not supplied) 2 Safety chain (supplied and mounted to oven) 3 Rear of cooker 4 Firmly fix chain to cooker rear 5 Kitchen wall Room ventilation All rooms require an openable window, or equvalent, and some rooms will require a permanent vent as well. 10/EN