Beko CEG5311Bio Owners Manual - Page 22

7 Troubleshooting Problem The appliance does not work. Cause Solution The appliance is not connected to the Plug in and press the switch. Check the mains. cable and the Plug. No or delayed response in several trials Appliance is under an electromagnetic Unplug the appliance. Restart after a of pressing a function key on the panel interference. Dirt over the panel. few minutes Clean the panel with the cloth provided. The coffee is not hot enough. The cups have not been preheated. The brewing unit is too cold. Warm up your cup by using steam function before you make coffee or rinse the cup with hot water. Make sure that the water in the water tank is not too cold. The coffee cannot come out from spout. Empty system function maybe used before. Coffee spout may not have been cleaned and blocked by coffee residues. Press the hot water button until water can come out from the spout. Clean the coffee spout. The first cup of coffee is poor quality. The first run of the grinder does not Throw the coffee away. The next cups pour a sufficient quantity of coffee into will be better. the brewing unit. The water tank is removed / the water The area near the water tank connector Wipe off the water around the water level is very low in the water tank but is wet. tank connector. there's no alert. The internal drip tray is filled with a lot The ground coffee is too fine, which Adjust the coffee fineness to bigger dot of water. blocks the water from coming out. during grinder operation. Coffee is delivered too slowly or a drop Coffee grounds are too fine, which Adjust the coffee fineness to bigger dot at a time. blocks the water from coming out. during grinder operation. The indicator flashes that there's not The internal coffee grounds outlet is Follow the steps described for Cleaning enough coffee beans, but there are blocked. coffee grounds outlet. plenty inside the container. The brewer or the coffee ground tray is The appliance did not finish the self- Please switch on the machine again and impossible to remove. cleaning process and was switched off . let it finish its auto cleaning process. The appliance no longer performs the rinsing cycle when switched on or off. Improper handling when servicing the appliance may be the cause. 1. When the appliance is on, remove the service door. 2. Press and hold the on/off button until you hear 2 beeps. 3. Replace service door. The touch buttons are not sensitive. Not pressing the touch button from the Press the lower bottom part of the icon front direction of the appliance. of the touch button from the front di- rection of the appliance. 22 / EN Fully Automatic Coffee Machine / User Manual