Beko CEP5152 Owners Manual - Page 18

6 Cleaning and Maintaining Your Machine 6.1 Daily Cleaning 1. Always make sure the Control Knob (5) is in the " " position and the machine is powered off by pressing the Power Button (11) on the side of the machine so that the blue light is turned off. Unplug the cord from the outlet and allow all of the parts to cool before cleaning. 2. Remove and wash the frothing sleeve (12) and wipe the frothing wand (10) with a damp cloth. 3. The water tank (3), sieves and drip tray (9) can be washed in a solution of hot water and mild liquid soap. A CAUTION: Do not immerse appliance in water, in any other liquid or place in the dishwasher. C Never use abrasive cleansers, steel wool pads or other abrasive materials to clean the machine. 6.2 Cleaning the Frothing Wand It is recommended to purge (chapter 6, point 3) and wipe the frothing wand (10) clean with a damp cloth each and every time immediately after frothing or steaming milk to prevent build up. Thoroughly clean the frothing wand before turning off the machine to ensure cleanliness. 1. Pull the black frothing sleeve (12) down and off the frothing wand (10) and clean under warm running water. 2. Fill a cup with a bit of water and immerse the frothing wand (10). 3. Turn the Control Knob (5) to the right towards the "Steam icon" and let steam push into the water for a few seconds. 4. Turn the Control Knob (5) back towards the center to the OFF position " ". 5. Use a cloth to dry the frothing wand (10) and replace the black frothing sleeve (12), ensuring it is firmly pushed up onto the frothing wand. 6. If extremely clogged, the frothing tip can be unscrewed, and soaked in warm soapy water for approximately 30 minutes. Once soaking is complete, thoroughly rinse the tip under running water. CAUTION: The frothing wand A (10), frothing tip, and frothing sleeve (12) may be VERY HOT! To avoid potential injury, always make sure that all parts have cooled down completely before handling. C If no steam comes out of the frothing wand (10), hardened milk blocks its path. Turn the Control Knob (5) back to the " " position. Remove the black frothing sleeve (12) and carefully use a needle to loosen the milk residue from the opening of the frothing tip to remove any blockage, then steam again. C In order for your machine to work properly time after time, clean the frothing wand (10), sleeve and tip after each use as described above. 18 / EN Manual Espresso Machine / User Manual