Beltronics RX75 Owner's Manual - Page 8
Details of Programming Options - install
UPC - 065789230758
View all Beltronics RX75 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Details of Programming Options Signal Strength Meter MeterSTD (Standard meter) The meter displays the band, and bar graph showing signal strength. (factory default) MeterTHT (Threat Display™) The meter simultaneously tracks multiple radar signals and provides the relative signal strength for each signal received. MeterTEC (TechDisplay) The meter displays the actual numeric frequency of the radar signal being received. Note: See more details on page 8. AutoMute aMute ON (AutoMute on) In this setting, the RX75's audio alerts will initially be at the volume you set, but after a few seconds, the RX75 will automatically reduce the volume level, to keep you informed, but not annoyed. (factory default) aMuteOFF (AutoMute off) With AutoMute off, the RX75's audio alerts will remain at the volume you set for the duration of the radar encounter. Voice Alerts Note: Voice is only available when the optional speaker is installed. VoiceON (Voice announcements on) In this setting, all radar and laser alerts, including SWS messages, will be announced in a digital voice, followed by the normal tone. (factory default) VoiceOff (Voice announcements off) In this setting, the standard tones will be used. 12 Details of Programming Options City Mode Sensitivity City STD (Standard) In this setting, when you put the RX75 in the City mode, X-band sensitivity is significantly reduced, to minimize annoyance from X-band intrusion alarms and motion sensors. (factory default) City LoX (Low X-band sensitivity) In this setting, when you put the RX75 in the City mode, X-band sensitivity is reduced more than the standard setting. This will reduce X-band alarms from other sources even further, but also significantly reduces range to X-band traffic radar. City NoX (No X-band sensitivity) In this setting, when you put the RX75 in the City mode, the RX75 will not respond to any X-band signals. WARNING: Only choose this setting if you are absolutely certain that there are no Xband traffic radar units where you drive. Note: These settings only apply when the RX75 is operated in City mode. X-band sensitivity is not affected when used in "AutoScan" or "Highway" modes. Brightness Brt AUTO (Auto) Display brightness automatically adjusted to suit the ambient lighting in your vehicle. Brt MIN (Minimum) Sets display to minimum brightness. Brt MED (Medium) Sets display to medium brightness. Brt MAX (Maximum) Sets display to maximum brightness. Brt DARK (Dark) In this setting, the RX75 will only display a very dim HD, AD, or CD for the power-on indication, and will not show any visual alerts when signals are detected. Bands BandsALL In this setting, all radar, laser, and SWS frequencies are monitored. This is the factory default setting, and it is highly recommended that you use your RX75 in this mode. BandsMOD In this setting, the RX75 will warn you with an audible alert and a text message, that one or more bands have been turned off in programming (i.e. "SWS OFF"). This warning is displayed during the start-up sequence (standard or fast). WARNING: Do not disable a radar or laser band unless you are certain it is not used for speed measurement in your area. 13