Beltronics STi Driver Owner's Manual - Page 9

Details of Programming Display Disp STD In this setting, the display will provide all information in its normal orientation. NOTE: When you are using the Dark mode, the display will not display anything. Only the power-on indication on the SmartPlug will illuminate. ̇ Standard Orientation Disp INV In this setting, the detector can be mounted upside down and all information will be inverted so it's readable. NOTE: A high or low voltage warning is given any time the vehicle's voltage drops below 10.5 volts, or goes above 16.5 volts. This feature is always on, regardless of the Pilot setting. ̇ Inverted Orientation Pilot (Power-on indication) Pilot HWY (Full description) In this setting, the STi DRIVER will display "Highway," "AutoScan," "City," or "CityNox" as its power-on indication. (factory default) Pilot H (Letter) In this setting, the STi DRIVER will display "H" for Highway, "A" for AutoScan,"C" for City, and "Cnx" for City NoX. Alamp Alamp On (alert lamp on) In this setting, the backlit VOLUME/MUTE will flash on and off during an alert. AlampOFF (alert lamp off) In this setting, the VOLUME/MUTE backlit button will not flash on and off during an alert. Voice Voice On (Voice announcements on) In this setting, all radar, laser, and SWS messages (if programmed) will be announced using a digital voice. Pilot V (Vehicle voltage) In this setting, the STi DRIVER will continually display "H" for Highway, A" for AutoScan,"C" for City, and "Cnx" for City NoX, and the vehicle's voltage. Voice Off (Voice announcements off) In this setting, only the distinct audio tone will be heard when a radar, Laser, or SWS message is detected. 14 Power-on Sequence PwrOnSTD (Standard) In this setting, each time you turn on the STi DRIVER, it will display "Bel STi," "LASER," "Ka-band," "K-band," "X-band," followed by a brief SWS alert. (factory default) If any of the factory default bands have been disabled, a double X-band tone and corresponding message (i.e. "X OFF"), will alert you that one or more bands have been turned off. PwrOnFST (Fast power-on) In this setting, the STi DRIVER will provide a single X-band tone if the factory default settings have not been changed. If any of the factory default band settings have been disabled, a double X-band tone and corresponding message (i.e. "X OFF"), will alert you that one or more bands have been turned off. Signal Strength Meter MeterSTD (Standard meter) In this setting, the meter displays the band of the received signal, and a bar graph shows the relative signal strength. (factory default) MeterTHT (Threat Display) In this setting, the meter will simultaneously track multiple radar signals, including relative signal strength for each. MeterTEC (Tech Display meter) In this setting, the meter displays the actual numeric frequency of the radar signal received. NOTE: The Tech Display feature is explained in more detail on page 11. AutoMute aMute ON (AutoMute on) In this setting, the STi DRIVER's audio alerts will initially be at the volume you set, but after a few seconds, the STi DRIVER will automatically reduce the volume level, to keep you informed, but not annoyed. (factory default) aMuteOFF (AutoMute off) With AutoMute off, the STi DRIVER's audio alerts will remain at the volume you set for the duration of the radar encounter. 15