BenQ W1210ST User Manual - Page 18
Shutting down the projector, Securing the projector, Using a security cable lock
View all BenQ W1210ST manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Shutting down the projector 1. Press on the projector or confirmation message. on the remote control. The projector displays a shutdown 2. Press or a second time. The POWER indicator light flashes orange and the fans run for about two minutes to cool the lamp. The projector doesn't respond to any commands during the cooling process. 3. When the cooling process ends, a "Power Off Ring Tone" will be heard, and the POWER indicator light will show a solid orange. To turn off the ring tone, see Power On/Off Ring Tone for details. If the projector will not be used for an extended period, unplug the power cable from the power outlet. Avoid turning on the projector immediately after turning it off as excessive heat may shorten lamp life. The actual lamp life may vary due to different environmental conditions and usage. Securing the projector Using a security cable lock The projector has to be installed in a safe place to prevent theft. Otherwise, purchase a lock, such as the Kensington lock, to secure the projector. You can locate a Kensington lock slot on the projector. See item 23 on page 8 for details. A Kensington security cable lock is usually a combination of key(s) and the lock. Refer to the lock's documentation to learn how to use it. Utilizing the password function For security purposes and to prevent unauthorized use, you may set up password security via the OnScreen Display (OSD) menu. Once the password is set and the function is enabled, the projector is password-protected. Users who do not know the correct password may not use the projector. You will be inconvenienced if you enable the password function yet forget the password somehow. Do make a note of your password, and keep the note in a safe place for later recall. Setting a password Once a password has been set and the power on lock is enabled, the projector cannot be used unless the correct password is entered every time the projector is started. To do this, first and foremost, you have to access the Advanced OSD menu (see page 25 for details). 1. Go to System Setup : Advanced > Password to display the Password window. 2. Select Change Password and press OK to display the Input New Password window. 18 Operation