Bernina 125 Manual - Page 18

4. Adjust stitch regulator 29 so that the zero line of the scale will be a little under the sign of demarcation on the right-hand side of the scale. This can be done only if lock screw 30 is not turned in too much. 5. Turn zigzag adjusting knob 31 to the right, from 0-4, according to the desired width of the stitch. The more the knob is turned to the right, the wider the zigzag stitch will he. Never turn knob 31, when the machine is stopped and the needle is stitched in the fabric. While sewing, however, the knob may freely be moved. 6. Insert sewing table. The Elastic Mending of Jersey fat manner: Cut out the piece for mending according to the desired form and size. Lay it on the damaged part of the cloth, in the direction of the meshes. The wrong side of both pieces must be on the top. Fix the pieces by provisional stitches around the damaged part. Then, oversew the border of the piece for mending with zigzag stitch (stitch length No. 1 and width No. 3 or 4). Next to this seam make another one inside of it, at the distance of about half presser foot. Cut the damaged part of the cloth along the inner seam and remove the provisional stitches. 32 2nd manner: Lay the piece for mending under the damaged part of the cloth (Fig. a), in the di- rection of the meshes. The wrong side of both pieces must be on the top. a Fix the pieces by provi- sional stitches around the damaged part (Fig. b). Then, sew a zigzag seam along these stitches (Fig. c) with stitch length No. 1 and width No. 3 or 4. Next to it, at the distance of about half presser foot, b sew another zigzag seam. Cut the damaged part of the cloth along the inner seam, while the super- fluous part of the piece • for mending is cut along the outer seam. Then remove the provisional stitches. Fix. 23 33