Bissell CleanView Helix Plus Vacuum User Guide - English - Page 12

Maintenance and care Clearing a clog 3. Low suction or poor pickup may be due to a clog in the vacuum cleaner. If you notice a change in the sound of the motor or a reduction in the spinning action, check for clogs. 1. Unplug cleaner from electrical outlet. 2. Empty dirt container. 4. 3. Check upper tank for build up or clogs. 4. Check the suction inlet for a clog. 5. Grasp the quick reach handle and lift hose wand to separate from the suction opening. Check for a clog in the base, the wand or the hose. 6. Remove the screw attaching the hose 6. wand base to the vacuum. Straighten the hose wand base and unclog with long, narrow object such as a broom stick. 7. If the clog persists, follow the instructions for Checking the rotating floor brush on page 10 and inspect the air passageway for obstructions. Replace light bulb 2. Use only BISSELL Replacement Bulbs in your BISSELL CleanView Helix. selected models only 1. Unplug cleaner from electrical outlet. 2. Using a flat screwdriver, table knife or coin, insert into the slot on the right of the lens and gently push inner latch to the left as shown to remove the lens. 3. 3. Reposition lens by inserting the tab on left side and then pushing the right side back into place. Suction Inlet Remove Screw 12 w w w. b i s s e l l . c o m 800.237.7691