Bissell CleanView Helix Plus Vacuum User Guide - English - Page 8

Operations Power cord storage When you have finished using your BISSELL CleanView Helix, return it to the upright position and store the power cord. 1. Turn vacuum cleaner off. 2. Unplug power cord by grasping the polarized plug (NOT the cord) and disconnect from outlet. NOTICE: While vacuuming, certain carpets and low humidity conditions may generate small static discharges. The discharges are entirely harmless and are not associated in any way with the main power supply. 3. Loop power cord around cord wraps on side of vacuum cleaner. 4. Clip molded plug to power cord to secure. Maintenance and care To maintain maximum cleaning performance, the following maintenance steps must be performed: 1. Empty the dirt container when the dirt reaches the "Full" line on the side. 2. Check the inner and outer circular filters and the pre-motor filter at least once a month and clean or replace as needed. WARNING: To reduce the risk of electric shock, turn power switch OFF and disconnect polarized plug from electrical outlet before performing maintenance or troubleshooting checks. 3. Replace the post-motor filter every six months. Note: More frequent filter cleaning or replacing may be necessary if you are vacuuming new carpet, fine dust or have allergy concerns. Follow the instructions on the following pages to perform these simple maintenance steps. Empty Dirt Container Tip: For maximum cleaning performance, check and clean or replace all filters as suggested. The dirt container needs to be emptied when the dirt reaches the "Full" line on the side of the container. 1. Unplug cleaner from electrical outlet. 2. 2. Slide the Lock 'n Seal lever to the "Unlock" position. Full Line 3. Grasp dirt cup portion handle and pull straight out to remove from vacuum. 4. Empty dirt into garbage container. Unlock Position Lock Position 8 w w w. b i s s e l l . c o m 800.237.7691