Bissell CrossWave Cordless Multi-Surface Wet Dry Vac 2551 User Guide - Page 5
Assembly, Charging the Battery
View all Bissell CrossWave Cordless Multi-Surface Wet Dry Vac 2551 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Assembly WARNING Do not plug in your CrossWave® Cordless until you are familiar with all instructions and operating procedures. 1 Insert Handle into Body of 2 unit until you hear a "click". click Then, on the back of the machine, align Clean Water Tank with the grooves and slide tank into place until you hear a "click". click 3 Wrap the Charging Adapter Cord around the tabs on the bottom of the 3-in-1 Docking Station. 4 Slide the overhang in the middle of the Brush Roll Drying Tray with Rinse Funnel down into the opening on the Storage Tray that is indicated with arrows. Then, place the Rinse Cup into the Rinse Funnel. NOTE: The 3-in-1 Docking Station functions as a Rinse and Clean Out Tray, Charging Station and Storage Tray for the machine and Brush Roll. Charging the Battery 1 2 3 4h Lift and place your CrossWave® Cordless onto the 3-in-1 Docking Station to charge. Plug the adapter into a suitable wall outlet. The Battery Life Indicator Lights will illuminate when charging. If LED lights do not turn on, realign the unit on the 3-in-1 Docking Station. For maximum run time, charge unit for 4 hours prior to use. Refer to chart below to understand the charging status. NOTE: Make sure unit is fully charged before first use. To check the battery status, remove the unit from the charging base and turn the unit ON by pressing either the Area Rug or Hard Floor Button. Battery is fully charged when all three white status lights are illuminated. www.BISSELL.com 5