Bissell CrossWave Cordless Multi-Surface Wet Dry Vac 2551 User Guide - Page 7

Cleaning Your Floors ATTENTION Do not overwet carpet. Be careful not to run over loose objects or edges of area rugs. Stalling the brush may result in premature belt failure. 1 Select cleaning mode: To start cleaning your hard floors, turn the machine ON by pressing the HARD FLOOR Button or RUG Button. Once the setting is selected, the dry vacuum will turn ON. To turn OFF, press the HARD FLOOR Button or RUG Button a second time. Area Rug Mode dispenses twice as much solution as Hard Floor Mode. Before cleaning area rugs, check the manufacturer's tag and test an inconspicuous spot on the rug for colorfastness. Do not use on silk or delicate rugs. 2 3 Recline the Body of the machine backward to start the Brush Roll spinning. To stop the Brush Roll spinning, you will need to stand the machine upright. Before each use, hold the Solution Spray Trigger for 10 seconds to prime the system with cleaning solution. LED lights illuminate when holding the trigger. NOTE: When solution is flowing, you will see bubbles forming at the edges of the Brush Roll Window. 4 5 To clean, hold the Solution Spray Trigger to apply solution on both forward and backward passes. To dry floors faster, release the trigger and clean a second pass without dispensing solution. TIP: When cleaning excessively dirty or muddy hard floors, or if your Brush Roll looks dirty, use the 3-in-1 Docking Station to rinse your Brush Roll before cleaning your area rugs. TIP: For overly challenging and stuck-on messes on your hard floors, activate the RUG mode and hold your CrossWave® Cordless over the mess. Using short passes while holding the trigger allows the multi-surface brush to go to work. www.BISSELL.com 7