Bissell Powerlifter Pet Rewind Vacuum 1792 User Guide - Page 6

Operations: Power On & Settings, Tools

Page 6 highlights

Tools To attach any of the included tools, remove the lower wand base from the foot of the vacuum and from both hose clips. Insert the desired tool firmly into the hose end. Pet Crevice Tool Use END side as standard crevice tool. Twist to SIDE to open up suction across rubber fingers for upholstery and large surface areas. Extension Wand Attach with desired tool for longer reach. Dusting Brush Use brush to dust furniture, blinds, books, lamps, shelves and baseboards. Pet TurboEraser™ Tool Remove tool by pulling away and downwards from vacuum. For best use, press the brush gently down and pull towards you in raking motion; too much pressure will cause brush to stop rotating. Pet Hair Eraser™ Tool Move sweeper from side to side. When you hear "click", reverse the motion. Clean inside the dirt bin by pressing on the side tabs gently to open. You can use a damp cloth or towel to clean excess dirt and any excess hair. Connect the hose to use with the vacuum or you can use without the hose connection. NOTE: The Pet Hair Eraser Tool and Dusting Brush do not store on the vacuum. Operations: Power On & Settings 1 To power ON, step on the RED Power Switch Pedal located near the bottom and center on the back side of the unit. Push the lower Handle Recline Pedal two times for an even lower recline. 6 www.BISSELL.com 2 Turn dial on foot to adjust to 1 of 5 height adjustments. Lowest Setting: For low pile carpet and bare floors. Medium Setting: For medium pile carpet. Highest Setting: For high pile and most shag carpet. Adjust to high setting if difficult to push. NOTE: For optimal cleaning, adjust to the lowest practical setting. If your vacuum is difficult to push, or is pushing larger debris, adjust to the next higher setting.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24

www.BISSELL.com
6
Operations: Power On & Settings
Tools
To power ON, step on
the RED Power Switch
Pedal located near the
bottom and center on
the back side of the
unit. Push the lower
Handle Recline Pedal
two times for an even
lower recline.
NOTE:
For optimal cleaning, adjust to the lowest
practical setting. If your vacuum is difficult to push, or is
pushing larger debris, adjust to the next higher setting.
Turn dial on foot to adjust to 1 of 5 height adjustments.
Lowest Setting:
For low pile
carpet and bare floors.
Medium Setting:
For medium
pile carpet.
Highest Setting:
For high pile
and most shag carpet. Adjust to
high setting if difficult to push.
To attach any of
the included tools,
remove the lower
wand base from the
foot of the vacuum
and from both hose
clips. Insert the
desired tool firmly
into the hose end.
NOTE:
The Pet Hair Eraser Tool and Dusting Brush do not store on the vacuum.
1
2
Pet Crevice Tool
Use END side as
standard crevice tool.
Twist to SIDE to open
up suction across
rubber fingers for
upholstery and large
surface areas.
Extension Wand
Attach with desired
tool for longer reach.
Pet Hair Eraser™ Tool
Move sweeper from
side to side. When you
hear “click”, reverse the
motion. Clean inside the
dirt bin by pressing on the
side tabs gently to open.
You can use a damp cloth
or towel to clean excess
dirt and any excess hair.
Connect the hose to use
with the vacuum or you
can use without the hose
connection.
Pet TurboEraser™ Tool
Remove tool by pulling
away and downwards
from vacuum. For best
use, press the brush
gently down and pull
towards you in raking
motion; too much
pressure will cause brush
to stop rotating.
Dusting Brush
Use brush to dust
furniture, blinds, books,
lamps, shelves and
baseboards.