Bissell ProHeat Pet Turbo Carpet Cleaner 1799V User Guide - Page 10
Notice, Warning
View all Bissell ProHeat Pet Turbo Carpet Cleaner 1799V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Storing Your Machine Once your cleaning is complete, make sure the the 2-in-1 tank and SmartMix® Tank is emptied and rinsed out. Store in a closet or basement for the next use. Troubleshooting Below are some of the issues you may run into. If you don't see the issue you're experiencing below, visit support.BISSELL.com. Problem Possible Cause Bladder may be empty. Filter may be clogged. Tanks may not be seated properly. Reduced spray Pump may have lost prime. or no spray Pump belt may be broken. The 2-in-1 and SmartMix® Tanks are empty. Cleaning mode switch is not fully on a mode. DirtLifter® PowerBrush does not turn Brush belt or pump belt is off or broken. Reduced suction or no suction ReadyTools™ Dial may be on the wrong setting for the cleaning job. 2-in-1 Tank lid is not properly installed. 2-in-1 Tank is not properly seated. Poor tool position. (Handheld attachments only.) 2-in-1 Tank has picked up maximum dirty water. Remedies Refill bladder with hot tap water. Clean out the flow indicator following steps on page 8. Turn power OFF (O); remove & reseat tanks. Turn power OFF (O); after 1 minute turn ON and press trigger. Turn ON the machine and check to see that the DirtLifter PowerBrush turns. Refill tanks according to page 4. Ensure the dial is in the correct position. Turn the machine OFF (O) and unplug from the outlet. To check if the brush belt or pump belt has broken, you will need a flathead screwdriver. Insert the blade end into the lower slot of the Belt Access Door to release the lower snap. If necessary, insert the blade end into the upper slot to release the upper snap. Examine the belt for breakage. If broken, visit BISSELL.com for replacement part information. Set ReadyTools™ Dial to the proper setting, depending on how you are using your machine. Reinstall lid following steps on page 4. 2-in-1 Tank must be firmly seated to function; remove and reseat tank. Adjust angle; apply more downward pressure. Empty tank following steps on page 8. WARNING To reduce the risk of fire, electric shock, or injury, turn power OFF and disconnect plug from electrical outlet before performing maintenance or troubleshooting. NOTICE To reduce the risk of a leaking condition, do not store machine where freezing may occur. Damage to internal components may result. 10 BISSELL.com