Bissell Rewind CleanView Pet User Guide - Page 10

Maintenance and care Checking rotating floor brush and drive belt Check your vacuum's rotating floor brush and drive belt regularly for wear or damage. 3. 1. Turn power OFF. Unplug vacuum cord from electrical outlet. 2. Place handle in low position and turn vacuum over so bottom side is facing up. 3. Using a screwdriver, remove the five screws and lift brush cover off. 4. Grasp rotating floor brush at both ends 4. and lift. Motor 5. Clean strings, hair and other debris from Pulley rotating floor brush, motor pulley and drive belt areas. Brush Cover 6. Check drive belt for wear, cuts or stressed areas. 7. 7. Check air passageway for obstructions. Remove debris from this area. Replace drive belt 1. Turn power OFF. Unplug vacuum cord from electrical outlet. 2. With rotating brush removed (steps 1-4 of checking rotating floor brush and drive belt), grasp old drive belt and remove from motor pulley. Discard old drive belt. 3. Place new drive belt over motor pulley and stretch other end over rotating floor brush in the space between the bristles. 4. Place ends of rotating floor brush down into slots. 5. Turn rotating floor brush by hand in the direction of the motor pulley. If properly installed, drive belt will center itself on rotating brush. 6. Reposition brush cover and fasten 5 screws back into place. Air Passageway 3 &4. Motor Pulley 6. 10 www.bissell.com Brush Cover 800.237.7691