Bissell Total Floors Pet User Guide - Page 5
Warning - filter
View all Bissell Total Floors Pet manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Assembly The only tool you'll need to assemble your vacuum cleaner is a Phillips screwdriver. Attach handle to vacuum Important: before assembling and using your vacuum place Filter into vacuum as shown to the right (A). 1. Locate the carry handle. Remove the screw packet taped to the carry handle. 2. There are three screws. Two screws are used to attach the upper handle to the vacuum body. One is for the hose guide/tool caddy. 3. Stand the vacuum upright. From the back of the vacuum, slide the base of the handle firmly into the grooves at the top of the vacuum body. Continue to push so that there are no gaps and the front of the handle is flush with the vacuum body. 4. Place carrying handle into place on to the back of the upper handle and insert two screws into the existing holes. Tighten securely with a Phillips screwdriver. Attach the vacuum hose & tools 1. Attach the 3 hose/tool storage pieces to the back of the unit. a. Attach the TurboBrush®/Pet TurboEraser™ holder to the back of the handle by snapping the piece into the unit as shown. Push piece straight in until it snaps into place. b. Attach the hose clip to the left side of the back of the vacuum. Insert tab at a 45 degree angle and turn clockwise so it snaps into place. c. The hose guide/tool caddy should be attached at the bottom of the back of the vacuum. Slide into place and insert screw into the existing hole. Tighten securely with a Phillips screwdriver. 2. Line up the tabs of the Twist n' Snap hose with the corresponding notches and turn clockwise. Slide the end of the hose into the hose grip base. Hose wraps on back of unit as shown on page 4. w w w. b i s s e l l . c o m Warning: Plastic film can be dangerous. To avoid danger or suffocation, keep away from babies and children. A. 1. 3. 4. a. b. c. 5 800.237.7691