Bissell Total Floors Pet User Guide - Page 6

Assembly Attach the vacuum hose & tools continued 3. Place the TurboBrush® Tool or Pet TurboEraser™ Tool into its holder from the front of the vacuum. Power cord To store the power cord, wrap cord around the upper and lower cord wrap on the side of the vacuum. To release the power cord, rotate the upper cord wrap down and gently pull off cord. Power switch The power switch is located just below the carrying handle on the side of the vacuum. Push the rocker switch "ON" (I) to vacuum, and "OFF" (O) when cleaning is complete. Brush Roll Power The rotating brush ON/OFF pedal is located on the foot of the vacuum. You can use your foot to engage or disengage this pedal (A). When the brush roll pedal has been engaged, the brush will start rotating. The brush roll should be turned on for most carpeted floors. To turn the brush roll off, disengage the pedal by pressing on it with your foot. We recommend turning off the brush roll for bare floor cleaning to prevent scatter or for other delicate surfaces. Edge Suction To make edge cleaning more convenient, remove the hose from the base and attach the crevice tool. Insert the crevice tool into the port on the foot of the vacuum (B). Suction is now diverted to the front corner of the vacuum and you can clean along edges and into corners. It is recommended you turn off the brush roll when using this feature. CAUTION: Before using your vacuum, make sure that the dirt container is in the locked position and that all filters (pre-motor and post-motor) are in place. Do not operate your vacuum without these filters. Tip: Your vacuum features a quickrelease cord wrap. To remove the power cord quickly and easily, rotate the upper cord wrap towards the floor, and slip the cord off. A (B) Tip: Do not use extension wand when using the Edge Suction Feature. 6 w w w. b i s s e l l . c o m 800.237.7691