Black & Decker HLVA320J26 Instruction Manual - Page 5

Hz hertz W watts min minutes or AC alternating current or DC.....direct current no no load speed Class I Construction (grounded earthing terminal safety alert symbol Class II Construction (double insulated) .../min or rpm...revolutions or reciprocation per minute Wh Watt Hours ASSEMBLY WARNING: Do not attempt to modify or repair the appliance Wall Mounting • The product can be wall mounted, if desired, using the wall mount bracket, screws and anchors supplied. To wall mount the vac, refer to Figures B, C, D and E. • Figure B - Mark the location of the screw holes (within reach of an electrical outlet for chargeing the vac while it is on the wall bracket). • Figure C - Insert the charger cord into the curved slot in the wall mount bracket 8 leaving approximately 8-9 inches (203mm - 227mm) excess as shown. Fig. B Fig. C 8 8 English Fig. E 10 Charging the battery WARNING: For use only with the supplied charger. From new, the rechargeable cells of the product need a minimum charge time of 16 hours to ensure full power. • The switch must be in the off ("O") position, the product will not charge if it is in any other position. • Figure F - Plug the jack plug 10 of the charger into the charging socket 3 of the tool. Plug the charger into any standard 120 Volt 60 Hz electrical outlet. Fig. F 10 • Figure D - Hang the vac on the wall by placing the opening on the base of the vac over the hooks in the wall mount bracket as shown in Figure C. Fig. D • While charging, the charger may get warm, this is perfectly normal and safe. It is safe to leave the appliance connected to the charger indefinitely. The charger automatically reduces power consumption when charging is complete. WARNING: Do not charge the battery at ambient temperatures below 39°F (4°C) or above 104°F (40°C). USE Switching on and off (Fig. G) • Figure F - To start, slide the On/Off switch 1 forward (i.e. "O"= Off, "I" = On). • To stop, slide the switch back. • Return the product to the charger immediately after use so that it will be ready and fully charged for the next use. Ensure that the product is fully engaged with the charger plug. • Figure E - Insert the jack plug 10 nto the charging socket. 3