Bosch 1640VS Operating Instructions - Page 9
Assembly of Miter Table Attachment FS2000 - accessories
UPC - 000346309652
View all Bosch 1640VS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
BM 2610006360 03-09:BM 2610006360 03-09 3/18/09 1:42 PM Page 9 If necessary, wipe the blade clean. Only then should the saw teeth protector be removed. Insert plug into power source and turn tool on briefly (See Operating Instructions Section). This will allow the saw blade pin to engage into the blade, which drives the blade back and forth. Turn tool off. To change the blade, place the saw teeth protector onto the blade and press the "Clic " button. This causes the tab to spring out of the locking spring, then remove the blade. FIG. 8 SMALL TAB DRIVE PIN LARGE TAB HOOK LOCKING SPRING Assembly of Miter Table Attachment FS2000 (Not included, available as accessory) MOUNTING MITER TABLE ATTACHMENT USING CLAMPS Remove the thumbscrew from the storage area located on the underside of the miter table fixture (Fig. 2). Place the stop on the table attachment against the edge of the workbench or table, and fasten the miter table attachment with the aid of the two matching table clamps (not included). To do this properly, slide the table clamps in completely in (Fig. 9). FIG. 9 MOUNTING MITER TABLE ATTACHMENT WITH SCREWS Your miter table attachment is equipped with two mounting holes that will allow you to more permanently mount the miter table attachment to a surface without the use of the table clamps (Fig. 10). To attach, simply screw two screws of sufficient length (not provided) through the two holes provided in the miter table attachment and into the mounting surface. FIG. 10 MOUNTING SCREW HOLE STOP TABLE CLAMP (not included) TABLE CLAMP (not included) MOUNTING SCREW HOLE ATTACHING THE SAW Place the tool as shown in figure 2 on the pivoting saw holder of the turntable and secure with thumbscrew. Make sure that the guide pins located on the miter table attachment engage in the holes on the tool. -9-