Bosch B26FT70SNS Instructions for Use - Page 6

Installation - model

Get Bosch B26FT70SNS PDF manuals and user guides View all Bosch B26FT70SNS manuals
Add to My Manuals
Save this manual to your list of manuals

Page 6 highlights

en Installation Transport and installation The appliance is heavy and must be secured during transport and installation. WARNING Risk of injury! The appliance is very heavy. It can fall over and cause serious injuries during transport and installation. At least two people are required to install the appliance safely. Keep the refrigerator doors closed until the appliance is upright and level at the installation location. Installation location WARNING Risk of explosion! Do not install the appliance near explosive or flammable substances. NOTICE If a panel or cupboard is installed above the appliance, ensure to leave a 13/32I (10 mm) gap so that the appliance can be pulled out of the recess if required. The air heated at the back of the appliance must be allowed to escape unhindered. To ensure that the doors can open all the way, maintain the lateral minimum clearances when installing the appliance in a corner or recess (see section on "Appliance and installation dimensions"). If the depth of the adjacent kitchen equipment exceeds 29ā1/8I (75 cm), maintain the minimum lateral clearances in order to utilize the full door opening angle (see section "Door opening angle"). Subsurface NOTICE Ventilation Never cover the ventilation openings on the front base panel or rear cover plate. This forces the appliance to work harder, increasing its power consumption. The appliance is very heavy. The floor on which the appliance is to be installed must be rigid. Reinforce the floor, if necessary. Weight of appliance when empty: Basic model 324 lb (147 kg) Do not install the appliance outdoors. The installation location should be dry and should not be exposed to frost. The best installation location is a dry, well ventilated room. The installation location should neither be exposed to direct sunlight nor should it be near a heat source, such as a stove, radiator, etc. If installation next to a heat source is unavoidable, use a suitable insulating plate or observe the following minimum distances to the heat source: S 1ā1/4I (3 cm) to electric or gas stoves. S 11ā3/16I (30 cm) to oil or solid fuel stoves. If installing the refrigerator next to another refrigerator/freezer, there must be a minimum clearance of 1" (25 mm) between the appliances to prevent condensation. 6

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
6
Installation
Transport
and
installation
The appliance
is
heavy
and must be
secured during
transport
and
installation
.
WARNING
Risk
of
injury!
The
appliance
is
very heavy. It can
fall
over and cause serious
injuries
during
transport
and installation.
At
least
two
people
are
required
to
install
the appliance
safely.
Keep
the refrigerator
doors closed until
the appliance
is
upright and level
at
the installation
location.
Installation
location
WARNING
Risk of explosion!
Do
not install
the
appliance
near
explosive
or
flammable
substances.
NOTICE
Do not
install the appliance
outdoors
.
The
installation
location
should be
dry and should
not
be exposed
to
frost
.
The best
installation
location
is
a dry,
w
ell ventilated
room
.
The installation
location
should
neither
be exposed
to
direct
sunlight nor should
it
be
near
a
heat
source,
such
as
a stove,
radiator,
etc
.
If
installation
next
to
a heat source
is
unavoidable,
use a suitable
insulating
plate or observe
the
follo
w
ing minimum
distances
to
the
heat
source:
S
1ɗ
1/4
I
(3±cm)
to electric
or gas
stoves
.
S
11ɗ
3/16
I
(30±cm)
to
oil or solid
fuel
stoves
.
If
installing
the
refrigerator
next to
another refrigerator/freezer, there
must
be
a
minimum
clearance
of
1"
(25
mm)
bet
w
een
the
appliances
to
prevent
condensation
.
If
a panel
or
cupboard
is
installed
above
the appliance,
ensure to
leave
a
13/32
I
(10±mm)
gap
so
that the
appliance
can
be pulled
out
of
the
recess
if
required
.
The air
heated
at
the bac
k
of
the
appliance
must be allo
w
ed
to
escape
unhindered
.
To
ensure that
the doors can
open all
the
w
ay,
maintain
the lateral minimum
clearances
w
hen
installing
the
appliance
in
a corner
or
recess
(see
section
on "Appliance
and
installation
dimensions")
.
If
the depth
of
the adjacent
k
itchen
equipment
exceeds
29ɗ
1/8
I
(75
cm),
maintain
the minimum
lateral
clearances
in
order
to
utilize the full
door
opening
angle (see section
"Door
opening
angle")
.
Subsurface
NOTICE
The appliance
is
very heavy
.
The floor on
w
hich
the appliance
is
to
be
installed
must be rigid
.
Reinforce the floor,
if
necessary
.
Weight
of
appliance
w
hen
empty:
Basic model
324±lb
(147±
k
g)
Ventilation
Never
cover
the ventilation
openings
on
the front base panel or
rear cover
plate
.
This
forces
the appliance
to
w
or
k
harder,
increasing
its
po
w
er
consumption
.
en