Bosch HBL8651UC Installation Instructions - Page 4

9 IMPORTANT SAFETY INSTRUCTIONS READ AND SAVE THESE INSTRUCTIONS Safety WARNING: If the information in this manual is not followed exactly, fire or shock may result causing property damage or personal injury. WARNING: Do not repair or replace any part of the appliance unless specifically recommended in the manuals. Improper installation, service or maintenance can cause injury or property damage. Refer to this manual for guidance. All servicing should be done by a qualified technician. Appliance Handling Safety Do not lift appliance by door handle. Remove the door for easier handling and installation. See instructions in Use and Care Manual. Unit is heavy and requires at least two people or proper equipment to move. Hidden surfaces may have sharp edges. Use caution when reaching behind or under appliance. Safety Codes and Standards This appliance complies with one or more of the following Standards: • UL 858, Household Electric Ranges • UL 923, Microwave Cooking Appliances • UL 507, The Standard for the Safety of Electric Fans • CAN/CSA-C22.2 No. 113-M1984 Fans and Ventilators It is the responsibility of the owner and the installer to determine if additional requirements and/or standards apply to specific installations. Electric Safety Before you plug in an electrical cord, be sure all controls are in the OFF position. If required by the National Electrical Code (or Canadian Electrical Code), this appliance must be installed on a separate branch circuit. Installer - show the owner the location of the circuit breaker or fuse. Mark it for easy reference. Important - Save these instructions for the local electrical inspector's use. Before installing, turn power OFF at the service panel. Lock service panel to prevent power from being turned ON accidentally. Refer to data plate for more information. See "Data Plate" under "Service" for data plate location. Be sure your appliance is properly installed and grounded by a qualified technician. Installation, electrical connections and grounding must comply with all applicable codes. Related Equipment Safety Remove all tape and packaging before using the appliance. Destroy the packaging after unpacking the appliance. Never allow children to play with packaging material. Never modify or alter the construction of the appliance. For example, do not remove leveling legs, panels, wire covers or anti-tip brackets/screws. Transport To avoid damage to the oven vent, use the transport method shown in the picture below. Support the bottom of the oven from side to side when moving it into the installation location. Leave the unit attached to the shipping pallet until it is in front of the oven cavity, ready to lift into place. English 1