Bosch PGL985UC Operating Instructions - Page 15

IMPORTANT INFORMATION Requirements for the cabinet Figure 1a D A E C F B The appliance is delivered from factory with the clips and gasket (underside edge of cooktop) in place. They should not be removed under any circumstances. The seal ensures that the entire work surface will be watertight, and prevents water seepage. If an oven is not to be installed below the cooktop, it is recommended to install a separator blocking access to the underside of the cooktop. To install the cooktop over an oven, check the dimensions given in the installation manual. 3 - Simultaneously press the edges so that the cooktop rests on its entire perimeter. Fig. 2 a. Figure 2a A- Minimum 6" (152 mm) D- Minimum 2" (51 mm) B- Minimum 6" (152 mm) E- Minimum 36" (915 mm) C- Minimum 30" (762 mm) F- Minimum 18" (458 mm) Maximum depth of cabinets installed above cooktop: 13" (330 mm.) Appliance installation Place the cooktop in the middle of the opening where it is to be inserted into the kitchen unit. Turn the 6 fastening clips Fig. 2 b. and screw them tightly into the kitchen unit. Never remove them. Figure 2b min. 213/16" 191/4" Figure 1b 331/2" min. 71/4" 331/2" min. 6" 13/4" 11/16" 11/16" 191/4" All operations relative to installation, adjustment and adaptation to another gas type must be carried out by authorized personnel from our Technical Service, and the codes in force, as well as the requisites of the gas companies must be complied with. 4 - Before connecting the appliance, ensure that the local connection conditions, as well as the gas type and pressure match the settings of the appliance. Ensure that the gas supply is cut off through the manual shut-off valve before connecting the appliance. The gas connection must be in a place that permits access to the manual shut-off valve and that, if necessary, is visible upon opening the kitchen cabinet door. 15