Bosch WTE86300US Operating, Care, Installation - Page 10
Installation ć, BuiltĆin, Installation, Check, list before, using the, dryer, Preparing to transport - troubleshooting
UPC - 825225845812
View all Bosch WTE86300US manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Installation ć step by step 1. Unpack the dryer. 2. Remove all objects from the drum. 3. Check the dryer for visible damage. 4. Position the dryer near the installation location. 5. Have the power supply cord fitted by an authorized technician (see page 8). 6. Move the dryer to its final location and align. CAUTION Do not slide dryer across the floor if heightĆadjustable feet have been extended. Feet and/or dryer base may be damaged if dryer is slid across floor with heightĆadjustable feet extended. 7. Position and then level the dryer. The dryer should be level with all four feet firmly on the ground. The dryer must not wobble. If the dryer is not level or if it does wobble, the feet must be adjusted. Adjust the heightĆadjustable feet until the dryer does not rock and is level, both frontĆtoĆback and sideĆtoĆside. 8. Insert plug into the wall receptacle. BuiltĆin Installation The appliance can be builtĆin; that is, you can install the dryer underĆcounter in a kitchen cabinet opening. The cabinet opening should be square and have dimensions as shown in the figure. a 600 mm minimum // 23 5/8" b 600 mm minimum // 23 5/8" c 850 mm minimum // 33 1/2" i If installed under a countertop, the countertop must be continuous and securely attached to neighboring cabinets. CAUTION An opening of at least 31 square inches (200 cm2) must be availĆ able at the front and side of the closet. Check list before using the dryer 1. Check that steps 1Ć8 have been implemented properly. 2. Ensure that the dryer is connected to the power supply. 3. Read the operating instructions to understand how your dryer operates. 4. Conduct an appliance test: q Check that the drum is empty. q Close the dryer door. q Switch the dryer to Extra Dry" and then press the Start button. q After 3Ć5 minutes press the Stop button and open the door. 5. If the interior of the dryer feels warm, the dryer has been connected properly. Switch the dryer to OFF". 6. If the dryer does not work, switch the dryer to OFF". Look in the troubleshooting section (page 20) of the OPERATING INSTRUCTIONS and find the fault. Preparing to transport the dryer ć step by step 1. Rotate the program selector to OFF". 2. Pull out power supply plug. 3. Place any accessories in the drum. 4. Close the door and secure with adhesive tape. 5. Screw the heightĆadjustable feet of the dryer into the housing to prevent them from being damaged during transportation. 10