Bosch WTE86300US Operating, Care, Installation - Page 8
Electrical, connection - -- dryer
UPC - 825225845812
View all Bosch WTE86300US manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Electrical connection d CAUTION d Power cord must be connected by a qualified person only. Connect to individual Brunch Circuit. Do not use an adapter. Do not use an extension cord. Do not remove ground prong. For CANADA Your dryer comes with a power supply cord, CSA listed in Canada. The Bosch dryer requires a 4Ćwire receptacle. When installing the receptacle for the dryer cord, ensure that the power supply cord is accessible when the dryer is in the installed position. The power cord should only be replaced by a qualified person. Use a 4Ćwire power supply cord (see electrical connection U.S.A. below). For U.S.A. Your dryer comes without a power supply cord. The power cord must meet the following requirements: - UL listed in the USA - 208 ć 240 volt rated (minimum) - 30 amps - Type SRDT or DRT (UL 2158) - Five feet long (minimum) - suitable for dryer 8 d CAUTION d Power cord must be connected by a licensed electrician only. Use only a U.L. approved 30 amp power cord with strain relief clamp note manufacturer's instructions. Do not plug end of power cord into a live receptacle before conĆ necting power cord to appliance terminals and closing junction/ splitter box as described below. Do not reuse old power cord. Cord must have closed loop or upturned end wire terminating connectors. Do not make a sharp bend or crimp wiring/conductor at conĆ nections. Only a 4Ćconductor cord shall be used when the appliance is installed in a mobile home, in a recreational vehicle, in a new branch circuit installation or an area where the local codes do not permit grounding through the neutral. The splitting box is located at the top rear of the appliance. To connect the power cord you have to remove the cover plate. 1. Remove the screws of the cover plate on the rear side of the appliance. 2. Push the cover plate from the front to the rear side and lift up. 3. Open the splitting box in the right corner (20 Torx). 4. Loosen the strain relief in the appliance. 5. Thread the power cord through the U.L. strain relief clamp. 6. Tighten the screws (2.5 Nm) of the U.L. strain relief clamp so that the power cord cannot be moved. 7. Connect the power cord as described below. 8. After connecting the power cord close the splitting box and replace the cover plate fasten in place with reverse handling. Dryer supplied to customer Connecting 4Ćwire power supply cord 1. Remove the screws from the cover of the terminal block. 2. Remove the screws from the grounding cable. 3. Remove the grounding cable. 4. Loosen the 2 screws labeled L in the terminal block. 5. Attach the power cord ground conductor (green) to the GROUND point. Tighten the screw (2.5 Nm) so that the ground conductor is held securely in place. 6. Attach the 2 power cord outer conductors (red and black) to the 2 terminals labeled L and the remaining power cord conductor (white) to the terminal labeled N.