Bosch WTE86300US Operating, Care, Installation - Page 9
Integrated socket, Condensate hose, connection - drain
UPC - 825225845812
View all Bosch WTE86300US manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
7. Tighten all 3 screws (3 Nm) so that the power conductors are held securely in place . 8. Check the U.L. strain relief clamp to make sure that it is tight and cannot be turned. 9. Replace the cover on the terminal block and fasten in place. i Make sure that the U.L. strain relief clamp is outside the cover! The appliance is now ready to be plugged into the 4Ćwire receptacle of the power rating. Connecting 3Ćwire power supply cord 1. Remove the screws from the cover of the terminal block located at the top rear of the appliance. 2. Make sure that there is a grounding cable. 3. Loosen the 2 screws labeled L and the screw labeled N in the terminal block. 4. Attach the 2 power cord outer conductors (red and black) to the 2 terminals labeled L and the remaining power cord conductor (white) to the terminal labeled N. 5. Tighten all 3 screws (3 Nm) so that the power conductors are held in place securely. 6. Check the U.L. strain relief clamp to make sure that it is tight and cannot be turned. 7. Replace the cover on the terminal block and fasten in place. i Make sure that the U.L. strain relief clamp is outside the cover! Additional grounding procedure - Some local regulations may require a separate ground. In such cases, the required accessory ground wire, clamp and screw must be purchased separately. - Never ground the dryer to plastic plumbing lines, gas lines or water pipes. Grounding instruction This appliance must be grounded. In the event of a malfunction or breakdown, grounding will reduce the risk of electric shock by providing a path of least resistance for the electric current. For Canada the dryer comes with a cord which has an equipment grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet which has been properly installed and grounded in accordance with all local regulations and ordinances. d CAUTION d Improper connection of the equipment grounding conductor may result in electric shock. Have the appliance checked by a qualified electrician or service technician if you are in doubt as to whether the dryer has been properly grounded. Integrated socket This appliance is equipped with a socket for connecting a washer without fuses. Only the listed washer may be connected. For all other connections Bosch will assume no liability. d CAUTION d Use copper conducters only. Connect to a 30 A minimum individual branch circuit, fused at 30 A maximum. Use receptable only for: 208 - 240 VAC 60 Hz 11 A washer: WFR2460UC, WFL2060UC. Condensate hose connection The dryer must have its condensate drain line installed and run to a suitable drain. The connection for the condensate hose is located on the back of the dryer. Connect the condensate drain hose to the dryer. The other end should then be placed and secured at nearby sink or drain. If installed with a washer it may, room permitting, be installed next to the washer drain hose and drained to the same drain used by the washer. Be sure to follow all local codes and regulations in running the condensate to a suitable drain. 9