Bosch WTE86300US Operating, Care, Installation - Page 20
Troubleshooting - 03 parts
UPC - 825225845812
View all Bosch WTE86300US manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Troubleshooting d WARNING! d RISK OF ELECTRICAL SHOCK ! EXPLOSION HAZARD! Repairs or replacement of parts may be carried out by authorized technicians only. Before calling the customer service, check whether you can rectify the fault yourself by means of the following table. If a fault cannot be rectified or a repair is required: 1. Set program selector to Off". 2. Turn off the circuit breaker. 3. Pull the mains plug out of the socket. 4. Call customer service (see page 21). Problem Possible cause Remedial action Dryer does not start. Start/Stop" indicator light does not illuminate. Main plug not inserted at all or not inserted correctly. Insert main plug correctly. A fuse of power supply has tripped. Replace/switch on fuse. Start/Stop" button not pressed. Press Start/Stop" button. No program selected. Select program. Door not closed. Close door. Ambient temperature below 41 °F/5 °C. Increase room temperature. Program has been interrupted. Filter" indicator light illuminates, a warning signal is emitted and the display shows E:01". Lint filter dirty. Fault in program sequence or malfunction. Clean filter as described on page 18. Switch off/switch on again. Switch off dryer, leave to cool down for 30 min, switch on again. Restart program. The room/cabinet is not adequately ventilated. Provide an adequate supply of fresh air. Switch off/switch on again. Drum light does not function. No program selected. Select program. Lightbulb defective, lightbulb burned out. Change light bulb, see page 19. No power supply. Guarantee power supply. Start/Stop" indicator light does not illuminate. Filter" indicator light flashes. Wrinkle block/Finished" indicator lights. The display shows 000". Fault in program sequence or malfunction. Moisture sensor dirty. Switch off dryer, leave to cool down for 30 min, switch on again. Restart program. Clean moisture sensor as described on page 19. Switch off/switch on again. Start/Stop" indicator light and Filter" Condensation outlet. indicator light flashes. Degree of drying has not been reached Lint filter dirty. or the drying time is too long. Display may indicate E:03". Laundry was too wet. Unsuitable program selected. Degree of drying has not been reached Maximum drying time was exceeded. or the drying time is too long. Display may indicate E:03". Motor limit temperature was exceeded. Water is not draining. Check hose for condensation outlet. Clean filter as described on page 18. Switch off/switch on again. Spin laundry at higher speed in the washing machine. Switch off/switch on again. Select program with aid of the program selection table (see page 23). Switch off/switch on again. Clean lint filter (see page 18). Check hose for condensation outlet. Spin laundry at a higher speed in your washer. Switch off dryer, leave to cool down for 30 min. Switch on again. Start program. Check the water drainage (if applicable). 20