Bosch WTE86300US Operating, Care, Installation - Page 17
Operation
UPC - 825225845812
View all Bosch WTE86300US manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Operation Using the dryer i Lint filter indicator flashes for 5 seconds - Check lint filter"! 1. Open the door. 4. If required, select Low heat J" by pressing the button. The Options" are explained on page 15. 5. If required, select Easy ironing" by pressing the button. The Options" are explained on page 15. i The estimated remaining time will be updated. 8. Press the Start/Stop" button. The Start/Stop" indicator light illuminates. If an automatic program has been selected, the indicator lights indicate the progress of the program sequence. i At the end of the program sequence damp dry is emitted (if set). 2. Check lint filter. The filter should be cleaned after and before every drying process. Cleaning the filter reduces the drying time and saves energy. 3. Rotate program selector to the desired program. Select the program which corresponds to the laundry in the dryer from the program selection table (see page 23). The dryer light turns on inside the drum. The Start/Stop" indicator light starts flashing. i The estimated remaining time will be indicated. 6. Place laundry in the empty drum. Put each piece of laundry into the machine separately. For best results the laundry to be dried must be sorted according to type of laundry and desired degree of drying. For further information see page 15. i Observe drying symbols of the laundry manufacturer. Ensure that there is only laundry in the drum. Check that all items are completely in the drum. 7. Close the door. i If the door has not been closed properly, the dryer will not start. i At program end the LED Wrinkle block/Finished" illuminates. i When the drying process is complete (program or selected time program ended), the drum rotates at specific intervals. This prevent the laundry from creasing (see Easy ironing", page 15). 9. Open the door. 10. Take the laundry out of the dryer. 11. Rotate the program selector to Off". The dryer light goes out. 12. Clean the filter. The filter should be cleaned after each drying process. Cleaning the filter reduces the drying time and saves energy. 13. Close the door. 17