Bosch WTMC8320US Installation and Use & Care (all languages) - Page 5

Caution, Attention, Warning - appliances

Page 5 highlights

Please ask your dealer or inquire at your local authority about the current means of disposal. Before installing the dryer Unpacking the appliance d CAUTION The dryer is very heavy. Do not lift it by yourself. Do not lift the appliance by projecting components (e.g. door) ć due to risk of breakage. ATTENTION Remove the appliance packaging carefully to prevent damage to the surfaces. Check the dryer for transportation damage. Do not connect a dryer which is visibly damaged. If in doubt, contact your dealer. Supplied components For U.S.A. d CAUTION The dryer is supplied without a power cord. The power cord must be connected by qualified persons only. ATTENTION After removing the packaging, immediately remove any objects from the drum. The dryer is delivered as a complete unit. The operating instructions and supplied accessories can be found in the drum. Installation location d WARNING d Do not install the dryer: - outdoors - in an environment with dripping water, - near flammable materials, - in rooms which are at risk of frost, - in rooms which may contain gas or other fuels, - in cupboards with lockable doors or in alcoves. The installation room must be well ventilated, otherwise the dryer will operate below optimum performance. Do not operate the dryer at temperatures above 104°F (40°C) and below 41°F (5°C). Low temperatures affect the automatic program sequence and may prolong the drying times. The installation surface for the dryer must be clean, level and firm. Do not install the appliance on carpets! Compensate for uneven floors with the heightĆadjustable feet. Install the dryer and level side to side and front to back. Use a bubble level. Never remove the heightĆadjustable feet! The size of the installation area depends on the dimensions of the dryer. Ensure that there is adequate room for the swivel range of the door! Minimum Installation Clearances Closet Sides 0" (O mm) Top 12" (3O5 mm) Rear* 0" (O mm) * as close to wall as venting will allow. Important information concerning minimum distances: - Depending on the location of the exhaust air connection, an additional minimum distance of 5½ inch (14 cm) must be provided on this side for pipes/brackets (see page 7). - Distances above the indicated minimum dimensions reduce the risk of mold formation behind the appliance. - Additional distances reduce noise transmission. - Additional distances facilitate installation and service. - If the dryer is installed in a small room, the doors of the room must be fitted with vents of a specified minimum size. Dimension Weight a 27.0" (686 mm) 125 lbs b 31.8" (808 mm) (56 kg) with c 37.2" (945 mm) packaging d 19.7" (500 mm)/ 143 lbs angle 170Ć180° (64 kg) If installing the dryer in a closet, observe the minimum distances according to the following table: The dryer door is delivered with hinges on the right. If required, the door hinges can be switched to the left side. If the door hinges are to be changed over, please contact your dealer or our customer serviceĆteam (see page 22). 5

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72

5
Please
ask
your
dealer
or
inquire
at
your
local
authority
about
the
current
means
of
disposal.
Before
installing
the±dryer
Unpacking
the
appliance
d
CAUTION
The
dryer
is
very
heavy.
Do
not
lift
it
by
yourself.
Do
not
lift
the
appliance
by
projecting
components
(e.g.
door)
ć
due
to
risk
of
breakage.
ATTENTION
Remove
the
appliance
packaging
carefully
to
prevent
damage
to
the
surfaces.
Check
the
dryer
for
transportation
damage.
Do
not
connect
a
dryer
which
is
visibly
damaged.
If
in
doubt,
contact
your
dealer.
Supplied
components
For
U.S.A.
d
CAUTION
The
dryer
is
supplied
without
a±power
cord.
The
power
cord
must
be
connected
by
qualified
persons
only.
ATTENTION
After
removing
the
packaging,
immediately
remove
any
objects
from
the
drum.
The
dryer
is
delivered
as
a
complete
unit.
The
operating
instructions
and
supplied
accessories
can
be
found
in
the
drum.
Installation
location
d
WARNING
d
Do
not
install
the
dryer:
-
outdoors
-
in
an
environment
with
dripping
water,
-
near
flammable
materials,
-
in
rooms
which
are
at
risk
of
frost,
-
in
rooms
which
may
contain
gas
or
other
fuels,
-
in
cupboards
with
lockable
doors
or
in
alcoves.
The
installation
room
must
be
well
ventilated,
otherwise
the
dryer
will
operate
below
optimum
performance.
Do
not
operate
the
dryer
at
temperatures
above
104
°
F
(40
°
C)
and
below
41
°
F
(5
°
C).
Low
temperatures
affect
the
automatic
program
sequence
and
may
prolong
the
drying
times.
The
installation
surface
for
the
dryer
must
be
clean,
level
and
firm.
Do
not
install
the
appliance
on
carpets!
Compensate
for
uneven
floors
with
the
heightĆadjustable
feet.
Install
the
dryer
and
level
side
to
side
and
front
to
back.
Use
a
bubble
level.
Never
remove
the
heightĆadjustable
feet!
The
size
of
the
installation
area
depends
on
the
dimensions
of
the
dryer.
Ensure
that
there
is
adequate
room
for
the
swivel
range
of
the
door!
Dimension
Weight
a
27.0"
(686
mm)
125
lbs
(56
kg)
b
31.8"
(808
mm)
(56
kg)
with
c
37.2"
(945
mm)
with
packaging
d
angle
19.7"
(500
mm)/
170Ć180°
packaging
143
lbs
(64
kg)
If
installing
the
dryer
in
a
closet,
observe
the
minimum
distances
according
to
the
following
table:
Minimum
Installation
Clearances
Closet
Sides
0"
(O
mm)
Top
12"
(3O5
mm)
Rear*
0"
(O
mm)
*
as
close
to
wall
as
venting
will
allow.
Important
information
concerning
minimum
distances:
-
Depending
on
the
location
of
the
exhaust
air
connection,
an
additional
minimum
distance
of
inch
(14
cm)
must
be
provided
on
this
side
for
pipes/brackets
(see
page
7).
-
Distances
above
the
indicated
minimum
dimensions
reduce
the
risk
of
mold
formation
behind
the
appliance.
-
Additional
distances
reduce
noise
transmission.
-
Additional
distances
facilitate
installation
and
service.
-
If
the
dryer
is
installed
in
a
small
room,
the
doors
of
the
room
must
be
fitted
with
vents
of
a
specified
minimum
size.
The
dryer
door
is
delivered
with
hinges
on
the
right.
If
required,
the
door
hinges
can
be
switched
to
the
left
side.
If
the
door
hinges
are
to
be
changed
over,
please
contact
your
dealer
or
our
customer
serviceĆteam
(see±page±22).