Bosch WTMC8320US Installation and Use & Care (all languages) - Page 9

ATTENTION Do not slide dryer across the floor if heightĆadjustable feet have been extended. Feet and/or dryer base may be damaged if dryer is slid across floor with heightĆadjustable feet extended. 10. Position and then level the dryer. The dryer should be level with all four feet firmly on the ground. The dryer must not wobble. If the dryer is not level or if it does wobble, the feet must be adjusted. Adjust the heightĆadjustable feet until the dryer does not rock and is level, both frontĆtoĆback and sideĆtoĆside. 11. Connect the exhaust duct to the exhaust air outlet on the dryer. 12. Insert plug into the wall receptacle. Check list before using the dryer 1. Check that steps 1Ć12 have been implemented properly. 2. Ensure that the dryer is connected to the power supply. 3. Read the operating instructions to understand how your dryer operates. 4. Conduct an appliance test: q Check that the drum is empty. q Close the dryer door. q Switch the dryer to Extra Dry" and then press the Start button. q After 3Ć5 minutes press the Stop button and open the door. 5. If the interior of the dryer feels warm, the dryer has been connected properly. Switch the dryer to OFF". 6. If the dryer does not work, switch the dryer to OFF". Look in the troubleshooting section (page 21) of the OPERATING INSTRUCTIONS and find the fault. Preparing to transport the dryer ć step by step 1. Rotate the program selector to OFF". 2. Pull out power supply plug. 3. Disconnect the exhaust duct from the exhaust air outlet on the dryer. 4. Place any accessories in the drum. 5. Close the door and secure with adhesive tape. 6. Screw the heightĆadjustable feet of the dryer into the housing to prevent them from being damaged during transportation. 9