Bose A20 Aviation 2010-2015 Owner's guide - Page 10
°e microphone assembly
View all Bose A20 Aviation 2010-2015 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Preparing the Headset for Use The microphone assembly Your headset may be shipped with the microphone assembly (boom microphone and cable) attached to the left earcup. If your headset is shipped with the microphone assembly packed separately, you can attach it to either earcup. Attaching the microphone assembly Choose the earcup (L or R) to receive the microphone assembly. Also, make sure that the earcup connector pins are clean and free of debris. 1. Use a Phillips screwdriver to loosen the two screws on the terminator cover near the bottom of the earcup where you want to attach the microphone assembly. 2. Remove the terminator cover to reveal the connector pins on the earcup. 3. Carefully line up the microphone assembly to the small connector socket on the earcup. 4. Slide the connector into the socket until it reaches the stop. L (left) Terminator cover Connector pins Microphone assembly Connector pins CAUTION: Do not force the connector into the socket, or earcup damage may occur. 5. Tighten the screws to secure the assembly. 6. Attach the terminator cover to the earcup that does not have the microphone assembly attached. Insert the screws, then align and tighten them. Note: The headset will not work without the terminator cover installed. CAUTION: Be sure to try the headset and fully test its operation before flight. 10 - English