Bose Acoustimass Powered Owner's guide - Page 15

Problem: The right cr left cube array doesn't play or sounds distorted. tion: off the Lifestyle' music center. Check ring connecting the cube array to the Aootistimasss bass module and make sure that the five-pin DIN connector is pushed in all the way into the back of the bass module. If no visible problem is found. disconnect the speaker cables from the back of the Lifestyle music center and reconnect them in the opposite terminals. If the cube array now works properly. the corresponding channel of the music center may be defective. Call your local authorized Bose® dealer. Problem: Not enough bass sound is being produced. Solution: Make sure the round openings on the Acoustimass bass module are not covered. If. after trying the above solutions. you are still having trouble with your Acoustimass powered speaker system, contact your authorized Bose dealer, who will verify any defects and arrange for service by an authorized service agency or by the Bose factory. Bose Corporation will make every effort to remedy any problem within the terms of the warranty, at 'mum inconvenience to you. Technical Information t3o Features Direct/Reflecting® speaker design Acoustimase) speaker system Dynamic Equalization Built-in amplification Syncom'c II computer quality assurance program Automatic protection circuitry Biamplified system Automatic turn-on/shutoff Driver Complement Two 6" (15.2cm) low-frequency drivers Four 2.5" (6.4cm) wide-range. magnetically shielded drivers in cube arrays Finish Acoustimass' module: Scratch-resistant vinyl veneer Cube array: Polymer finish Dimensions Aooustimass module: 46.4 cm H x 32.1 cm W x 25cm (1814/ " x 12slo" x 97W') Cube array: 18.7 cm H x 9.2 cm W x 11.7 cm 0 (7318" x x Weight 43 lb (19.5 kg), in shipping carton Power (Mains) Supply 120 volts - 60 Hz 220 volts 50 Hz 240 volts- 50 Hz USA/Canada Europe except UK United Kingdom/ Australia 120/220-240 volts 50/60 Hz International • 14