Brother International DS-740D Quick Setup Guide - Page 8

Product Safety Guide How to remove and dispose of the rechargeable Li-ion battery (DSmobile DS-940DW only) Turn off the machine and remove the USB cable from the machine before removing the rechargeable Li-ion battery. 1. P lace the machine face down and remove the Side Cover using a flathead screwdriver. 2. D isconnect the rechargeable Li-ion battery connector from the Printed Circuit Board Assembly (PCBA). Do not disconnect the Flexible Flat Cable (FFC). 3. Push the release tab (as illustrated) to remove the rechargeable Li-ion battery from the Side Cover. 4. C over the rechargeable Li-ion battery terminals with tape and dispose according to your local recycling laws. 1 2 3 4 NOTE • We do not recommend removing the rechargeable Li-ion battery unless disposing the scanner. • For more information about handling the rechargeable Li-ion battery, see the applicable instructions and warnings in this guide. Regulation IMPORTANT • Brother cannot accept any financial or other responsibilities that may be the result of your use of this information, including direct, special or consequential damages. There are no warranties extended or granted by this document. • This machine has been certified to comply with FCC standards, which are applied to the USA only. 8 Federal Communications Commission (FCC) supplier's Declaration of Conformity (For USA Only) Responsible Party: Brother International Corporation 200 Crossing Boulevard Bridgewater, NJ 08807-0911 USA TEL: (908) 704-1700 declares, that the products Product Name: DSmobile DS-635, DSmobile DS-640, DSmobile DS-740D, DSmobile DS-940DW complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: „„ Reorient or relocate the receiving antenna. „„ Increase the separation between the equipment and receiver. „„ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. „„ Consult the dealer or an experienced radio/TV technician for help. (DSmobile DS-940DW only) „„ This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. IMPORTANT • Changes or modifications not expressly approved by Brother Industries, Ltd. could void the user's authority to operate the equipment. • A specific shielded interface cable should be used to ensure compliance with the limits for a Class B digital device.