Brother International HL 4070CDW Quick Setup Guide - English - Page 35

Windows® Wireless Network Installing the Printer Driver Windows® 14 If your network is configured for Authentication and Encryption, the following screen will appear. When configuring your Brother wireless printer, you must ensure that it is configured to match the Authentication and Encryption settings of your existing wireless network. Choose the Authentication Method and Encryption Mode from the pull-downs in each setting box. Then enter the Network key and click Next. 16 Follow the on-screen instructions. „ For the users connected with a network cable for configuration: Disconnect the network cable between your access point (hub or router) and the printer, and click Next. Note • If you want to set other than WEP key1, click Advanced. • If you do not know the Authentication or Encryption settings for network, contact your network administrator. 15 Click Next. The settings will be sent to your printer. The settings will remain unchanged if you click Cancel. „ For the users connected without a network cable for configuration: Using the information you recorded in 9, return the wireless settings of your computer back to their original settings. Check the box if you confirm, and then click Next. Installing the printer driver Note • If you want to manually enter the IP address settings of your printer, click Change IP Address and enter the necessary IP address settings for your network. After making your selection, click Next and the Wizard will search for available wireless networks. • The control panel settings will be automatically changed to WLAN when the wireless settings are sent to your printer. Improper Setup • DO NOT try to cancel any of the screens during this installation. • If your wireless settings fail, and error message will appear during the installation of printer driver and the installation will be terminated. If you encounter this failure, please go to step 1 and setup the wireless connection again. 33