Brother International Innov-is BQ950 Operation Manual - Page 37
Checking the needle, Replacing the needle
View all Brother International Innov-is BQ950 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
Checking the needle Sewing with a bent needle is extremely dangerous since the needle may break while the machine is being operated. Before using the needle, place the flat side of the needle on a flat surface and check that the distance between the needle and the flat surface is even. Replacing the Needle Press . d • If is pressed while the presser foot is raised, an error message appears. Lower the presser foot. → The screen changes, and all keys and operation buttons are locked (except ). B GETTING READY 1 2 1 Flat side 2 Needle type marking CAUTION • If the distance between the needle and the flat surface is not even, the needle is bent. Do not use a bent needle. Hold the needle with your left hand, and then use a e screwdriver to turn the needle clamp screw toward you (counterclockwise) to remove the needle. • The needle clamp screw can also be loosened or tightened with the L-shaped (or disc-shaped) screwdriver. 2 1 1 Screwdriver 2 Needle clamp screw • Do not apply a strong force when loosening or tightening the needle clamp screw, otherwise certain parts of the machine may be damaged. 1 1 1 Flat surface With the flat side of the needle toward the rear of the f machine, insert the needle until it touches the needle stopper. 1 Replacing the needle Use the screwdriver and a needle that has been determined to be straight according to the instructions in "Checking the needle". Press (Needle position button) once or twice to a raise the needle. Place fabric or paper under the presser foot to cover b the hole in the needle plate. Note • Before replacing the needle, cover the hole in the needle plate with fabric or paper to prevent the needle from falling into the machine. Lower the presser foot. c 1 Needle stopper Basic operations B-29