Brother International Innov-is VM5100 Operation Manual - Page 283
ribbon embroidering needle, pull
View all Brother International Innov-is VM5100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 283 highlights
k Stop the machine, and thread and the bobbin then tie the upper thread together to secure the threads. CREATING BOBBIN WORK (EMBROIDERY) o Remove the fabric from the embroidery frame, and check the finished embroidery. A 1 How to Create Bobbin Work l Start sewing again to finish the pattern. m Raise the needle and presser foot, remove the embroidery frame, and then cut the upper thread and the bobbin thread. When cutting the threads, be sure to leave an adequate length of thread so they can be properly secured. a Right side of fabric b Wrong side of fabric p If the desired results could not be achieved, adjust the tension of the bobbin thread and the upper thread, and then try sewing the pattern again. For more details, refer to "ADJUSTING THE THREAD TENSION" on page A-16. Memo • Check bobbin after each bobbin work embroidery pattern is sewn to make sure there is adequate bobbin thread for the next pattern. • While selecting the bobbin work pattern, the embroidery speed value is set to "100 spm". Refer to "Adjusting the Embroidery Speed" on page E-33 to change the embroidery speed. n Using a hand sewing ribbon embroidering needle such needle, pull as a the bobbin thread to the top (wrong side) of the fabric, and then tie the upper thread and the bobbin thread together. Memo • If there is a gap between the start point and end point of the pattern, leave an adequate length of thread, cut the threads, and remove the fabric from the machine. Use a ribbon embroidering needle to hand sew stitches to connect the starting and ending points. Appendix A-15