Brother International Innov-is VM5100 Operation Manual - Page 98
Dart Seam
View all Brother International Innov-is VM5100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 98 highlights
SEWING THE STITCHES ■ Basting a Select and attach presser foot "J". b Press the "Reverse Stitch" button to sew reinforcement stitches, then continue sewing. Dart Seam a Select and attach presser foot "J". b Sew dart a reverse stitch at the beginning of and then sew from the wide end to the the other end without stretching the fabric. * If automatic reinforcement stitching is preset, a reinforcement stitch will automatically be sewn at the beginning of sewing. Memo • When you use the basting stitch for gathering, do not use a reinforcement stitch at the beginning; you should lift the presser foot, rotate the handwheel toward you (counterclockwise), pull up the bobbin thread and pull a length of top and bobbin thread out from the rear of the machine. • You can set the stitch length between 5 mm (approx. 3/16 inch) and 30 mm (approx. 1-3/16 inches) a Basting c Cut the thread at the end leaving 50 mm (approx. 2 inches), and then tie both ends together. * Do not sew a reverse stitch at the end. a Between 5 mm (approx. 3/16 inch) and 30 mm (approx. 1-3/16 inches) c Sew while keeping the fabric straight. d Insert the ends of the thread with a hand sewing needle. into the dart d End the basting with reinforcement stitches. S-28