Brother International Innov-is VM5100 Operation Manual - Page 74
Using the Foot Controller
View all Brother International Innov-is VM5100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
SEWING g Press the sewing. "Start/Stop" button to start * Guide the fabric lightly by hand. Note • When cutting thread thicker than #30, nylon monofilament thread, or other decorative threads, use the thread cutter on the side of the machine. Memo • When the foot controller is being used, you cannot start sewing by pressing the "Start/Stop" button. h Press the sewing. "Start/Stop" button again to stop i Press the "Thread Cutter" button the upper and lower threads. to trim j When the needle has stopped moving, raise the presser foot and remove the fabric. Memo • This machine is equipped with a bobbin thread sensor that warns you when the bobbin thread is almost empty. When the bobbin thread is nearly empty, the machine automatically stops. However, if the "Start/Stop" button is pressed, a few stitches can be sewn. When the warning displays, re-thread the machine immediately. ■ Using the Foot Controller You can also use the foot controller to start and stop sewing. CAUTION • Do not allow fabric pieces and dust to collect in the foot controller. Doing so could cause a fire or an electric shock. → The needle will return to the up position automatically. CAUTION • Do not press the "Thread Cutter" button after the threads have been cut. Doing so could tangle the thread or break the needle and damage the machine. • Do not press the "Thread Cutter" button when there is no fabric set in the machine or during machine operation. The thread may tangle, possibly resulting in damage. Memo • When the foot controller is being used, you cannot start sewing by pressing the "Start/Stop" button. (For embroidery and sewing machine only) • The foot controller cannot be used when embroidering. • The foot controller can be used for sewing utility and decorative stitches when the embroidery unit is attached. S-4