Brother International Innov-is VM5100 Operation Manual - Page 304
Transmitting by USB
View all Brother International Innov-is VM5100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 304 highlights
ERROR MESSAGES Marks Error Messages This stitch is not "Dual Feed Mode" compatible. This USB media cannot be used. Cause/Solution This message appears when the optional dual feed foot cannot be used with the current stitch. Select other stitch. (see page B-67) This message is displayed when you try to use incompatible media. This USB media is incompatible. This message is displayed when you try to use incompatible USB media. For a list of compatible USB media, visit " http://solutions.brother.com ". To thread the needle, please remove the fabric from under the This message is displayed if you press the "Automatic presser foot. Threading" button while the dual feed foot is attached and the presser foot height is 3 mm (1/8 inches) or higher. Remove the fabric, and then press the "Automatic Threading" button again. Transmitting by USB This message is displayed while the USB media is transmitting. Turn off the power and replace the needle plate. USB media error This message is displayed when you try to sew with a stitch other than a middle needle position stitch while the single-hole needle plate is installed. This message is displayed when the needle plate is removed with the machine on or when the machine is turned on and "Embroidery" or "Embroidery Edit" mode is selected (see page B-22). This message is displayed when an error occurs with the USB media. USB media is not loaded. Load USB media. This message is displayed when you try to recall or save a pattern while no USB media is loaded. Use the presser foot lifter button to lower the presser foot. This message is displayed when a button, such as the "Start/Stop" button, is pushed while the presser foot is raised. When the speed controller is set to control the zigzag stitch width, the "Start/Stop" button does not operate. This message is displayed when the speed control lever is set to control the zigzag stitch width, and the "Start/Stop" button is pushed. Use the foot controller to operate the machine. A-36