Brother International KM-430B Network Users Manual - English - Page 20
Brother International KM-430B Manual
View all Brother International KM-430B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
6. Needle bar positioning ( I ) Turn the pulley to lower the needle bar to its lowest position. Loosen screw 4D, and move the needle bar up or down so that the top ®. reference line 0 on the needle bar meets the lovfer end of needle bar bushing * If a DP X 17 needle is used, adjust it so the second lowest reference line ® meets the lower end of the needle bar bushing. (2) After this adjustment, fit needle bar thread guide €) onto the needle bar, insert needle a) into place with its long groove facing the front, and fasten it with screw Q. (3) Raise the machine head, fit the driver onto the lower shaft, and install the shuttle hook. (4) Turn the pulley so that the lower end of the needle bar bushing so meets the second highest reference line in its ascent from the lowest position. At this time, move the driver so that the point of the shuttle hook meets the center of the needle, and tighten bolt (1) through the adjusting hole. * If a DP X 17 needle is used, adjust it so the ®. lowest reference line 0 meets the lower end of the needle bar bushing A ai , 02 r (b) 3 415