Brother International LB-6770THRD Users Manual - English - Page 36
the left, then pass the thread through the notch
View all Brother International LB-6770THRD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
GETTING READY Make sure that the thread is passed into the j thread take-up lever as shown below. a Pull the end of the thread, which has been m passed through the needle bar thread guide, to the left, then pass the thread through the notch of the thread guide (1), and then firmly pull the thread from the front and insert it into the slit of the thread guide disk marked "7" all the way (2). Make sure that the thread passes the notch of the thread guide. a Thread take-up lever Memo z If the needle is not raised, you cannot pass the thread into the thread take-up lever. Be sure to press the needle position button to raise the needle before passing the thread into the thread take-up lever. Pass the thread behind the needle bar thread k guide. The thread can easily be passed behind the needle bar thread guide by holding the thread in your left hand, then feeding the thread with your right hand, as shown. a b Ta a Notch of the thread guide b Thread guide disc Cut the thread with the cutter on the left side n of the machine. Ta a Needle bar thread guide Lower the presser foot lever to lower the l presser foot. a Thread cutter Note z When using thread that quickly winds off the spool, such as metallic thread, it may be difficult to thread the needle if the thread is cut.Therefore, instead of using the thread cutter, pull out about 80 mm (approx. 3 inches) of thread after passing it through the thread guide disks (marked "7"). a a Presser foot lever 34 a a 80 mm or more