Brother International MFC-J615W Quick Setup Guide - English - Page 28

For Wireless Network Users Connecting the Brother machine to the wireless network IMPORTANT You must have the wireless settings you wrote down for your network in step 17 on page 27 before you proceed. 18 Configure the wireless settings (typical Wireless Setup in infrastructure mode) a On your machine, press Menu. Press a or b to choose Network and press OK. Press a or b to choose WLAN and press OK. Press a or b to choose Setup Wizard and press OK. When Network I/F switched to Wireless. is displayed, press OK to accept. This will start the wireless setup wizard. To cancel, press Stop/Exit. b The machine will search for available SSIDs. If a list of SSIDs is displayed, use the a or b keys to choose the SSID you wrote down in step 17-a on page 27, then press OK. If you are using an authentication and encryption method that requires a Password (Network Key), go to c. If your authentication method is Open System and your encryption mode is None, go to d. Note It will take several seconds to display a list of available SSIDs. If a list of SSIDs is not displayed, make sure your access point is on. Move your machine closer to the access point and try starting from a again. If your access point is set to not broadcast the SSID, you will have to manually add the SSID name. For details, see the Network User's Guide on the documentation CD-ROM. c Enter the Password (Network Key) you wrote down in step 17-a on page 27 using the dial pad to choose each letter or number. For example, to enter the letter a, press the 2 key on the dial pad once. To enter the number 3, press the 3 key on the dial pad seven times. The letters appear in this order: lower case, upper case and then numbers. You can use the d and c keys to move the cursor left and right. (For more information, see Entering Text for Wireless Settings on page 39.) Press OK when you have entered all the characters, then press 1 for Yes to apply your settings. d Your machine will now try to connect to your wireless network using the information you have entered. It may take a few minutes to connect to your wireless network. e A connection result message appears for 60 seconds on the LCD and a wireless LAN report will automatically be printed. If the connection failed, check the error code on the printed report and refer to Troubleshooting on page 30. Wireless setup is now complete. A four level indicator on the bottom of your machine's LCD will show the wireless signal strength of your access point/router. To install MFL-Pro Suite, continue to step 19. For Windows® Users: Now go to Page 32 For Macintosh Users: Now go to Page 36 28