Brother International PR-600II Users Manual - English - Page 186

Using the Optional Cap Frame By using the optional cap frame, patterns can be embroidered onto caps and hats. The procedures for using the cap frame are described below. Cap frame and its accessories The cap frame driver and the mounting jig are required in order to use the cap frame. Cap frame 1 Embroidering area: Cap frame driver and 4 thumb screws 50 mm (H) × 130 mm (W) In order to attach the cap frame to (2 inches (H) × 5-1/8 inches (W)) the carriage, remove the 2 The mark indicates the center of the embroidery frame holder, and embroidering area. 3 Snap lock 1 then attach this cap frame driver to the carriage of the machine. 1 Insert the thumb screws into these holes and tighten the screws to secure the movable section. Use these holes when 2 storing this cap frame driver. 2 Holding Spring The cap frame is secured by the two holding Spring. 3 Mounting jig Use when framing a cap in the cap frame. 1 Holders 1 The cap frame is secured by the two holders. 2 Mounting bracket 2 Tighten thumb screw to secure to mounting surface. 3 Screws 3 Adjust the size of the 3 mounting jig according to the type of cap being embroidered. 1 2 Pad Allen screwdriver (large) Allen screwdriver (medium) * Use when adjusting the ring of the cap frame driver and the height of the L-shaped bracket. (Refer to page 173.) 7 Memo ● Before installing the cap frame, be sure to adjust the ring of the cap frame driver and the height of the L-shaped bracket. (If the same machine is being used, this adjustment is only required the first time that it is used. In addition, this adjustment is not necessary if the enclosed cap frame is installed.) ● After the ring of the cap frame driver and the height of the L-shaped bracket have been adjusted, they must be adjusted again if a different machine is being used. The height may differ depending on the machine that is used. For details, contact your sales representative. Note ● If the cap embroidery frame is attached, the embroidery frame indicators, showing which embroidery frames can be used, appear as shown below. Using the Optional Cap Frame 169