Brother International PR-600II Users Manual - English - Page 202
Installing the embroidery, frame holder
View all Brother International PR-600II manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 202 highlights
■ For the advanced cap frame After removing the brim holder, unlock the 2 snap lock of the cap frame, remove the clips, and then remove the cap. 1 Remove the two upper thumb screws 3 1 2 3 1 Brim holder 2 Snap lock 3 Clips Installing the embroidery frame holder After embroidering using the cap embroidery frame is finished, remove the needle plate spacer and cap frame driver, and then re-attach the embroidery frame holder. Remove the needle plate spacer. 1 1 Needle plate spacer Loosen the two lower thumb screws. 2 1 Thumb screws 1 Thumb screws Remove the cap frame driver. 4 Note ● Be careful that the cap frame driver does not hit any nearby parts, such as the presser foot. With the hole on the sweat guard holder 5 aligned with the centerline of the guiding plate, insert the two thumb screws removed in step 3 into the holes at the top, and then tighten the thumb screws. 3 3 1 7 2 1 Hole on the sweat guard holder 2 Centerline of guiding plate 3 Holes on the top • Insert the thumb screws into the holes where the cap frame driver that was originally installed (holes that the thumb screws were removed from in step 2 on page 171). X The movable section of the cap frame driver is secured. Using the Optional Cap Frame 185