Brother International PR-600II Users Manual - English - Page 189
plate of the cap frame driver.
View all Brother International PR-600II manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 189 highlights
APPENDIX Pass the machine bed through the ring of the 3 cap frame driver. Insert the pins on the frame-mounting plate of 5 the carriage into the holes in the mounting plate of the cap frame driver. 1 1 1 Machine bed Note ● Be careful that the cap frame driver does not hit any nearby parts, such as the presser foot. Attach the cap frame driver to the carriage as described below in steps 4 through 6. Insert the two thumb screws at the bottom of 4 the cap frame driver into the v-cuts in the carriage, and then place the mounting plate of the cap frame driver on top of the framemounting plate of the carriage. 2 1 Pins on the frame-mounting plate of the carriage 2 Holes in the mounting plate of the cap frame driver Insert and tighten the two upper thumb 6 screws in outer holes of mounting plate of cap frame driver. 3 4 2 1 1 Notch in the carriage 2 Thumb screw of the cap frame driver 3 Mounting plate of the cap frame driver 4 Frame-mounting plate of the carriage While pushing in the cap frame driver toward 7 the machine so that it is fully inserted, tighten the two lower thumb screws to secure the cap frame driver. X This completes the installation of the cap frame driver. 172