Brother International XL-2600 Users Manual - English - Page 19

Caution - tension

Get Brother International XL-2600 PDF manuals and user guides View all Brother International XL-2600 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 19 highlights

While holding the end of the thread, gently 4 press the foot controller to wind the thread CAUTION around the bobbin a few times. Then stop the machine. ● Make sure you follow the instructions carefully. If you do not cut the excess thread completely before winding the bobbin, when the thread runs low it may 1 tangle around the bobbin and cause the needle to break. Trim the excess thread above the bobbin. 5 CAUTION ● Not winding the bobbin properly may cause the thread tension to loosen, and may break the needle. Press the foot controller to start. 6 1 2 1 Wound evenly 2 Wound poorly When the bobbin seems full and begins 7 spinning slowly, take your foot off the foot controller. Cut the thread, slide the bobbin winder shaft 8 to the left and remove the bobbin. Note ● The needle bar does not move when you slide the bobbin winder shaft to the right. ● Immediately after winding the bobbin, it is normal to hear the sound of the clutch engaging when beginning to sew or turning the handwheel. 17

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
17
1
4
While holding the end of the thread, gently
press the foot controller to wind the thread
around the bobbin a few times. Then stop the
machine.
5
Trim the excess thread above the bobbin.
6
Press the foot controller to start.
7
When the bobbin seems full and begins
spinning slowly, take your foot off the foot
controller.
8
Cut the thread, slide the bobbin winder shaft
to the left and remove the bobbin.
Note
●
The needle bar does not move when you
slide the bobbin winder shaft to the right.
●
Immediately after winding the bobbin, it is
normal to hear the sound of the clutch
engaging when beginning to sew or turning
the handwheel.
●
Make sure you follow the instructions
carefully. If you do not cut the excess
thread completely before winding the
bobbin, when the thread runs low it may
tangle around the bobbin and cause the
needle to break.
●
Not winding the bobbin properly may
cause the thread tension to loosen, and
may break the needle.
1
Wound evenly
2
Wound poorly
CAUTION
CAUTION
1
2