Brother International XL-2600 Users Manual - English - Page 37
Adjusting Buttonholes
View all Brother International XL-2600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
Cut an opening in the middle of the 3 buttonhole with the seam ripper tool. Be careful not to cut through any stitches. CAUTION ● When using the seam ripper to open the buttonhole, do not put your hand or finger in the path of the ripper. The seam ripper may slip and you may be injured. After obtaining a satisfactory feed on the right 3 side, stitch the buttonhole and observe the feeding. If the left side is too coarse or fine compared 4 with the right side, adjust the buttonhole fine- adjustment screw as described below. If the left side is too coarse, turn the buttonhole fine-adjustment screw with a large screwdriver in the - direction. If the left side is too fine, turn the buttonhole fine-adjustment screw with a large screwdriver in the + direction. • This adjustment ensures both sides of the buttonhole are the same. 2 1 3 Adjusting Buttonholes If the stitching on the two sides of the buttonhole is not the same, you can make the following adjustments. Set the stitch length dial between "F" and 1.5 1 and sew the buttonhole on a scrap piece of fabric to observe how the material is fed. 4 4 4 If the right side of the buttonhole is too coarse 2 or fine, adjust the feeding of the material with the stitch length dial. 1 1 Stitch length dial 2 Buttonhole fine-adjustment screw 3 Left side 4 Buttonhole appearance 2 3 1 Right side 2 Shorter 3 Longer 35