Brother International XL-2600 Users Manual - English - Page 22

from Lower Threading. - threading a sewing machine

Get Brother International XL-2600 PDF manuals and user guides View all Brother International XL-2600 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 22 highlights

KNOWING YOUR SEWING MACHINE Follow steps 1 and 2 from "Lower Threading". 1 Put the bobbin in, feed the end of the thread 2 through the slit, and then pull the thread to cut it. Reattach the bobbin cover. Put the left tab in 3 place (see arrow 1), and then press lightly on the right side (see arrow 2) until the cover clicks into place. 2 1 • Only use bobbins that were designed to be used with this machine. CAUTION ● Make sure you set the bobbin so the thread unrolls in the right direction. If the thread unrolls in the wrong direction, it may cause the thread tension to be incorrect or break the needle. • You can begin sewing immediately without drawing up the bobbin thread. If you want to draw up the bobbin thread before you start to sew, follow the procedure in "Drawing up the Lower Thread" (page 24). 1 1 Cutter • Make sure that the thread is correctly inserted through the tension-adjusting spring of the bobbin case. If it is not inserted, reinsert the thread. 1 1 Tension-adjusting spring 20

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
KNOWING YOUR SEWING MACHINE
————————————————————————————————————————
20
1
Follow steps
1
and
2
from “Lower Threading”.
2
Put the bobbin in, feed the end of the thread
through the slit, and then pull the thread to cut it.
• Only use bobbins that were designed to be
used with this machine.
1
Cutter
• Make sure that the thread is correctly
inserted through the tension-adjusting spring
of the bobbin case. If it is not inserted, re-
insert the thread.
1
Tension-adjusting spring
3
Reattach the bobbin cover. Put the left tab in
place (see arrow
1
), and then press lightly on
the right side (see arrow
2
) until the cover
clicks into place.
• You can begin sewing immediately without
drawing up the bobbin thread. If you want to
draw up the bobbin thread before you start
to sew, follow the procedure in “Drawing up
the Lower Thread” (page 24).
●
Make sure you set the bobbin so the thread
unrolls in the right direction. If the thread
unrolls in the wrong direction, it may cause
the thread tension to be incorrect or break
the needle.
CAUTION
1
1
2
1